average voltage การใช้

• Since the average voltage across C1 is " V"
• Therefore, the average voltage across the switch is:
• The cells sustain a higher average voltage during discharge compared to alkaline batteries.
• The average voltage across the inductor is:
• Bulbs carry the 240 volt rating, which is correct for the average voltage delivered.
• Under this phase lock, the average voltage across the junction equals hf / 2e.
• When talking about alternating current ( AC ) there is a difference between instantaneous voltage and average voltage.
• With the phase particle trapped in a minimum, it has zero average velocity and therefore zero average voltage.
• As the averaging interval increases from zero to one hour, the average voltage stabilizes ( Fig . 2 b ).
• Normalising for voltage and current, etc . is it because the peak voltage of AC is higher than the average voltage?
• Using Na x C 6 as the anode, the average voltage on the low potential plateau was higher for Na cells than Li cells.
• Either the high or the low pulse of the zero bits can be extended to make the average voltage ( and thus the current ) either forward or reverse.
• Instantaneous voltages can be added for direct current ( DC ) and AC, but average voltages can be meaningfully added only when they apply to signals that all have the same frequency and phase.
• The amplitude, or the size, of the N1 is measured by taking the average voltage within the window that typically encompasses the N1 ( about 150 to 200 ms post-stimulus ).
• The average voltage at the collector is then equal to the supply voltage, and the signal voltage appearing across the tuned circuit varies from near zero to near twice the supply voltage during the RF cycle.
• Where \ scriptstyle \ bar V _ { \ text { L } } and \ scriptstyle \ bar V _ S are respectively the average voltage across the inductor and the switch over the commutation cycle.
• If you want to look more into prebuilt solutions, " pulse-width modified " is a way to describe an output that acheives an average voltage by turning a constant higher voltage on and off.
• The benistor is able to modulate the value of any or all of following parameters delivered to a load : maximum voltage, effective voltage, average voltage, maximum current, effective current, or average current.
• On long rural power distribution lines, special autotransformers with automatic tap-changing equipment are inserted as voltage regulators, so that customers at the far end of the line receive the same average voltage as those closer to the source.
• Multiply by the switching frequency on the load capacitances to get the current used, and multiply by the average voltage again to get the characteristic switching power dissipated by a CMOS device : P = 0.5 C V ^ 2 f.